Menu

header photo

The Maintenance Of Motor’s Tires

July 5, 2013

Tires is one of the most important parts in running system,its function is that: One, directly touch road and bear the motor’s weight. Two, wheels can make sure it don’t slipped because of reliable adhesion while driving. Three, take advantage of its flexibility after gas charging to abate and partly absorb shake and lash caused by bumpiest road.

The key to maintain motors are the following pointsFirst, keep there is charged pressure in tires , proper pressure of tires will make motor has larger traction, stability, ride comfort and long service life.if the pressure is not enough not only increasethe resistance that will raise load and fuel consumption of engine but also make the wheel drop from rim section. However , if the pressure is too enough, it may reduce motor’s stability, when you ride, you will feel it likes “jumping”.

Keep tires’ in good condition and cleanliness of tread. please check the wheels’ tread after riding. Clean scree and other things in tread pattern.such as little iron nail and little sheet iron, if you find them ,get them out, then check the inner tube was punctured whether or not. Repair motor’s outer cover is inadvisable,because after hot patching, the repaired place is higher than other’s place so that it will to pitch while riding, so the best method to repair is hot patching, if you lack tools or chucking about hot patching. You can use glue to do cold-patch.

If you usually ride on the dirty road, there always has iron scurf and cullet on the road, in order to avoid piercing inner tube that can’t be repaired,you can take a suit of special tool in your motor.they are : two tyre spoons ,a mini inflator, a pair of folding scissors,A tube of glue, some ready tire skin, the change of inner tube mainly base on its degree of aging and intact. Although the punctured type was already be mended,but compared with the new one ,its reliability is worse than it, the inner tube which has used for one year or ride up to 8000 kilometers must be changed into a new one. When change a new inner tube, you’d better to daub a thin french chalk on its surface, then put it into outer cover. This can prevent inner tube aging and become adherent to outer cover. When assemble and disassemble outer cover,you’d better to prepare a appropriative tyre spoon. Don’t use sharp tools in case hurt wheels in handling.

Avoid being under the blazing sun for quite a long time and being tainted with oil contamination.If the wheels was put under the sun, it will make wheels weather-shake,aging. So you should park it in the ventilated place where is dustproof, Sunscreen, rain-proof. Or you can cover a tarpaulin on the motor, it is benefit for wheels, mor importantly, it can protect paint, electroplating,plastic from damnifying. Oil, acid-base can corrode rubber, so you don’t let this things touch tires in you life,the motor you have long time not to use you should built on stilts it by wooden carcase. In case a little part of tires load for long time and become out of shape.

Need motorcycle tires info, please click www.motopartscenter.com/tires-and-wheels-c-163.html

 

Go Back

Comment